Supported Media
This printer supports the following paper specifications.
The type and quality of the paper will greatly affect print
quality. Be sure to use the correct paper for your needs.
Refer to the manual included with your paper or contact
the manufacturer for details regarding any precautions
or warnings that must be taken into consideration when
using that paper. Test the print quality first before
purchasing a large amount of paper.
c
Important:
Do not use paper that is wrinkled, scuffed, torn, or
dirty.
Roll Paper
Paper core size
2 inch and 3 inch
Roll paper
outer diameter
150 mm or less
Width
254 mm (10 inches) to 1,118 mm (44
inches)
Paper
Thickness
0.08 to 0.5 mm
Moving and Transporting
the Printer
This section describes how to move and transport the
product.
Moving the Printer
This section assumes that the product is being moved to
another location on the same floor without traversing
stairs, ramps, or lifts. See below for information on
moving the printer between floors, to another building,
or between non-level floors.
U
!
Caution:
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to observe
this precaution could result in the printer falling
over, causing accidents.
Getting Ready
Make the following preparations in advance before
moving the printer.
❏
Turn off the printer and remove all cables.
❏
Remove any paper.
❏
Remove any optional components if they are
installed.
❏
Unlock the stand locks.
Post-Move Setup
After you move the printer, configure the following
settings to get the printer ready for use.
❏
Check that the new location is appropriate.
U
Setup Guide
(Booklet)
❏
Plug in the power cables and turn the printer on.
U
Setup Guide
(Booklet)
❏
Perform a nozzle check to check for clogged
nozzles.
U
“Checking for clogged nozzles” on page 45
SC-F6000 Series User’s Guide
Appendix
65
