Epson Stylus WorkForce 30, Getting Started Manual

Page: 22 / 64

14
Sawgrass Technologies, Inc. ~ www.sawgrassink.com
8.
Firmly push down the plastic
cartridge set of dampers to completely
engage the ink dampers into place.
Note: You will have to push each
individual damper hinge into position
until it clicks into place. The printer will
not ‘recognize’ the ink damper until it is
firmly pushed into place.
10.
The plastic tubing comes pre-
attached to the plastic arm with two
adhesive bands. Position the plastic arm
on the far right side of the printer.
12.
Press printer ink button (second
button on the left side of the printer). The
printer will start to prime and reset itself.
The ink cartridge carriage will move in
position.
7.
Place the ink dampers into the empty
ink bay cartridge. The Black ink damper
should be on the far left side, the yellow
on the far right side.
9.
Install the plastic support arm. First
remove the adhesive backing on the back
of the plastic arm.
11.
The plastic arm should be aligned so
that the edge of the adhesive Velcro® is
situated at the top right hand corner of
the ink cartridge bay. Press the plastic
arm firmly to set the adhesive Velcro® in
place.
Congratulations. You have installed your WF30/T30/B40W Quick Connect
bulk ink system. You are now ready to install the ChromaBlast Driver
Software .