Epson Stylus Photo RX640 series, Service Manual

Page: 68 / 103

EPSON Stylus PHOTO RX640/650 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 68
4.5.7 Eject Frame Assy
1. Remove the Printer Mechanism (p.53)
2. Remove the Ferrite Core Holder (with hooks x2) from the Front Frame, and
remove the Head FFC.
(Fig. 4-70)
3. Release the harness of the CD-R sensor from the hook of the Eject Frame.
(Fig. 4-71 )
4. Remove the screw securing the Cable Holder Frame.
5. Remove the right and left screws (x2) securing the Front Frame, and remove the
Front Frame from the printer body.
6. Remove the Eject Frame Assy from the printer body. (Fig. 4-72)
Figure 4-70. Removing the Head FFC
Figure 4-71. Removing the Front Frame
Figure 4-72. Removing the Eject Frame Assy
„
Before installing the Eject Frame, install the Left EJ Frame
Spring (longer), and the Right EJ Frame Spring (shorter)
temporarily, in the respective positions shown below on the
Eject Frame. After installing the Front Frame, move the Right
EJ Frame Spring to the spring support.
„
Fit the shaft holders (left and right) on the underside of the
Eject Frame onto the Paper Eject Roller Shaft.
(Fig. 4-72)
„
After installing the Front Frame, confirm the engagement of
the projections (x2), and then tighten the screws in the
specified order.
(Fig. 4-71)
„
After installing the Cable Holder Frame, confirm the
engagement of the projection, and then tighten the screw.
(Fig. 4
-
71)
„
After installing the Head FFC as shown, move the carriage
several times and confirm that the FFC is free from undue
tension or excessive allowance.
(Fig. 4-70)
Right EJ Frame Spring
Left EJ Frame Spring
~Left side~ ~Right side~
~Temporarily~
Hook
Head FFC
Front Frame
Locate it on the folded part
Ferrite Core
Holder
Hooks (x2) at front bottom
1
2
Projection
Projection
Projection
Release the harness
Cable Holder Frame
Front Frame
C.B.S-TITE 3x6 (x2)
Torque : 0.8± 0.1N
·
m
C.B.S-TITE 3x6
Torque : 0.8±0.1N
·
m
Eject Frame Assy
Shaft holder
Shaft holder