3.
Press the OK button.
If the network connection is already set up, the connection details are displayed. Select
Change Settings
to
change the settings.
If the printer has already been connected by Ethernet, select
Change to Wi-Fi connection.
, and then select
Yes
after checking the message.
4.
Select
Push Button Setup (WPS)
.
5.
Hold down the [WPS] button on the access point until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
6.
Press the OK button on the printer.
7.
Press the OK button.
The screen automatically closes after a specific length of time.
Note:
If connection fails, restart the access point, move it closer to the printer, and try again. If it still does not work, print a
network connection report and check the solution.
8.
Press the
button.
Related Information
&
&
“Checking the Network Connection Status” on page 28
&
“When You Cannot Make Network Settings” on page 106
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can automatically connect to an access point by using a PIN code. You can use this method to set up if an
access point is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the access point.
User's Guide
Network Settings
24
