3 COnnECTIOn
6
EPSOn
S5U1C63000H6 ManUal
(S1C63 Family In-Circuit Emulator)
3.4 Installing Peripheral Circuit Board (S5U1C63
xxx
P)
By installing the S5U1C63xxxP peripheral circuit board (to be separately sold) into a slot of the S5U1C63000H6, a
debug system can be made corresponding to each device of the S1C63 Family. Figure 3.4.1 shows installing meth-
od of the peripheral circuit board. The S5U1C63000H6 is equipped with an LCD driver function, so an LCD board
is not required.
S5U1C63000
H6
DIAG
LC2
LC1
OFF
ON
(1), (4)
(2)
Peripheral circuit board
(2), (3)
Figure 3.4.1 Installing Peripheral Circuit Board
(1) Unfasten the screws located on the left and right sides of the front panel of the S5U1C63000H6 by turning them
counterclockwise then remove the front panel.
(2) Insert the peripheral circuit board into the slot and push it
using the jig attached with the S5U1C63000H6 as shown
in Figure 3.4.2.
Using this jig as a lever, push it toward the inside of the
board evenly on the left and right sides. After confirming
that the peripheral circuit board has been firmly fitted into
the internal slot of the S5U1C63000H6, remove the jig.
Figure 3.4.2 Installing Peripheral Circuit Board
(3) When dismounting the peripheral circuit board, set the jig
into position as shown in Figure 3.4.3. Using this jig as a
lever, push it toward the outside of the board evenly on the
left and right sides and pull the peripheral circuit board out
of the S5U1C63000H6.
(4) Mounting the front panel removed at the step (1) on the
main case by pushing and turning two screws located at
both side.
Figure 3.4.3 Dismounting Peripheral Circuit Board
(5) The jig has a magnet for keeping under the bottom plate of the case while not in use.
Peripheral circuit board
Peripheral circuit board
