Chapter 3 Installation and Configuration
S5U13515P00C100 Evaluation Board User Manual (Rev 1.1)
EPSON
7
Chapter 3 Installation and Configuration
The S5U13515P00C100 evaluation board incorporates a DIP switch, jumpers, and 0 ohm resistors which allow it to
be used with a variety of different configurations.
3.1 CNF[7:0] Configuration Inputs
The S2D13515 has 8 configuration inputs (CNF[7:0]), which can be configured through a combination of a DIP
switch and 0 ohm resistors. CNF[2:0] are dedicated inputs and are configured using DIP switch SW1. CNF[7:3] are
multiplexed with some host interface signals and are configured by 0 ohm resistors.
3.1.1 CNF[2:0]
CNF[2:0] are configured using DIP switch SW1 as described below.
The following figure shows the location of DIP switch SW1 on the S5U13515P00C100 evaluation board.
Figure 3-1: Configuration DIP Switch (SW1) Location
Table 3-1: CNF[2:0] Configuration Settings
CNF[2:0]
1 (connected to HIOVDD)
0 (connected to VSS)
CNF2
CNF[2:1] are used in combination with CNF[7:3] to select the host bus interface. For a
summary of the possible host bus interfaces, see Section Table 3-3 :, “Host Interface
Configuration Settings” on page 9.
CNF1
CNF0
OSCI is the source for Input Clock 1
CLKI is the source for Input Clock 1
= suggested settings