Epson RX595 - Stylus Photo Color Inkjet, Service Manual, Page: 87 / 131

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 87
4.5.4 APG Assy
1. Remove the Printer Mechanism (p.76)
2. At the right side of the printer, remove the screws (x2) securing the APG Assy.
(Fig. 4-66)
3. Release the hook at the top, and remove the APG Assy while taking care not to
lose gears or springs.
4. Remove the composite gear (10, 15.2).
Figure 4-66. Removing the APG Assy
Figure 4-67. Installing the APG Assy
C H E C K
P O I N T
The gears of the APG Assy are arranged as shown below:
Install the APG Assy by the following procedure: (Fig. 4-67)
1. Install the composite gear (10, 15.5).
2. Pass a pin (o2mm) or the like through the locating hole in the Right
PG Cam on the CR Guide Shaft and that in the printer frame.
3. Pass a pin or the like through the locating hole in the spur gear
28.8 and that in the APG Assy. With the pins left inserted in
the holes, install the APG Assy on the printer frame.
4. Make sure that all the hooks are engaged properly and the
protrusions fit in the printer frame, and tighten the screws in the
order shown in
Fig. 4-65 .
„ Lubrication is necessary. Refer to the following section and
lubricate the specified points:
LUBRICATION OF APG UNIT (p.119)
Locating hole
Spur gear 28.8
C.B.S-TITE 3x6 (x2)
Torque : 0.8±0.1N
·
m
1
2
APG Assy
Hook
Composite gear (10, 15.2)
ASF Gear Train
2. Pass a pin or the like
1. Install the composite gear
3. Pass a pin or the like
Right PG Cam
4. Check engagement
of the hooks
4. Install the
composite gear
Pin
Pin
With the pin left
in the hole