Epson RX-8564LC, Applications Manual

Page: 25 / 39

RX
−
8564 LC
Page
−
22 ETM12E-01
6) TIE bit ( Timer Interrupt Enable )
This bit is used to control output of interrupt signals from the /INT pin when a fixed-cycle timer interrupt
event has occurred.
When a "1" is written to this bit, occurrence of an interrupt event causes a low-level interrupt signal to be
output from /INT pin.
When a "0" is written to this bit, output from the /INT pin is prohibited (disabled).
TIE Data Description
0
1) When a fixed-cycle timer interrupt event occurs, an interrupt signal is not
generated or is canceled (/INT status remains Hi-Z).
2) When a fixed-cycle timer interrupt event occurs, the interrupt signal is
canceled (/INT status changes from low to Hi-Z).
Write / Read
1
When a fixed-cycle timer interrupt event occurs, an interrupt signal is
generated (/INT status changes from Hi-Z to low).
∗
Level interrupt mode (single-shot operation)
If the TIE bit value is changed from "0" to "1" without first canceling the
interrupt event, the /INT pin immediately goes to low level.
13.2.3. Fixed-cycle timer interrupt interval (example)
The combination of the source clock settings (settings in TD1 and TD0) and fixed-cycle timer countdown
setting (Reg
−
C setting) sets the fixed-cycle timer interrupt interval, as shown in the following examples.
Source clock
Timer Counter
setting
4096 Hz
TD1,0 = 0,0
64 Hz
TD1,0 = 0,1
1 Hz
(When seconds
setting is updated)
TD1,0 = 1,0
1/60 Hz
(When minutes
setting is updated)
TD1,0 = 1,1
0
(00h)
− − − −
1 (01h) 244.14
µ
s 15.625 ms 1 s 1 min
2 (02h) 488.28
µ
s 31.250 ms 2 s 2 min
3
(03h) 732.42
µ
s
46.875 ms 3 s 3 min
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
255
(FFh)
62.26 ms 3.984 s 255 s 255 min
•
Fixed-cycle timer interrupt time error and fixed-cycle timer interrupt interval time
A fixed-cycle timer interrupt time error is an error in the selected source clock's
+0
/
−
1
interval time.
Accordingly, the fixed-cycle timer interrupt's interval (one cycle) falls within the following range in
relation to the set time.
Fixed-cycle timer interrupt's interval
(Fixed-cycle timer interrupt's set time(
∗
)
−
source clock interval) to (fixed-cycle timer interrupt set time)
∗
) Fixed-cycle timer interrupt's set time = Source clock setting
×
Countdown timer setting for fixed-cycle timer
∗
The time actually set to the timer is adjusted by adding the time described above to the
communication time for the serial data transfer clock used for the setting.