Epson R380 - Stylus Photo Color Inkjet Printer, Service Manual

Page: 56 / 150

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Overview 57
4.1 Overview
This section describes procedures for disassembling the main components of the Stylus
Photo R260/R265/R270 and R360/R380/R390
Unless otherwise specified, disassembled units or components can be reassembled by
reversing the disassembly procedure.
Procedures which, if not strictly observed, could result in personal injury are described
under the heading “WARNING”.
“CAUTION” signals a precaution which, if ignored, could result in damage to
equipment.
Important tips for procedures are described under the heading “CHECK POINT”.
If the assembly procedure is different from the reversed disassembly procedure, the
correct procedure is described under the heading “REASSEMBLY”.
Any adjustments required after reassembly of components or parts are described under
the heading “ADJUSTMENT REQUIRED”.
When you have to remove any components or parts that are not described in this
chapter, refer to the exploded diagrams in the appendix.
The precautions in the two lists below (WARNING and CAUTION), must always be
followed during disassembly and assembly.
4.1.1 Precautions
See the precautions given under the heading “WARNING” and “CAUTION” in the following
column when disassembling Stylus photo R260/R265/R270 and R360/R380/R390.
W A R N I N G
„ Disconnect the power cable before disassembling or assembling
the printer.
„ If you need to work on the printer with power applied, strictly
follow the instructions in this manual.
„ Wear protective goggles to protect your eyes from ink. If ink
gets in your eye, flush the eye with fresh water and see a doctor
immediately.
„ Always wear gloves for disassembly and reassembly to avoid
injury from sharp metal edges.
„ Use static discharge equipment such as anti-static wrist straps
when accessing internal components to protect sensitive
electronic components and circuitry.
„ Never touch the ink or wasted ink with bare hands. If ink comes
into contact with your skin, wash it off with soap and water
immediately. If irritation occurs, contact a physician.
„ Make sure the tip of the waste ink tube is located at correct
position when reassembling the waste ink tube, or it will cause
ink leakage.
C A U T I O N
„ When transporting, do not remove the ink cartridges. Pack the
printer with the cartridges installed.
„ Use only recommended tools for disassembly, assembly or
adjustment of the printer. (
Table 4-1, “List of Tools,” on
page 58 )
„ Be sure to tighten the screws to the specified torque.
„ Apply lubricants and adhesives as specified. (See Chapter 6
Lubrication (p.131) for details.)
„ Make the specified adjustments when you disassemble the
printer. (Chapter 5 contains additional information on
adjustments.
„ When using compressed air products, such as air duster, for
cleaning during repair and maintenance, the use of such
products containing flammable gas is prohibited.
„ Be careful not to scratch or damage the coating on exterior
surface of the product during disassembly and reassembly.