Epson PhotoPC 3000Z, Service Manual

Page: 64 / 109

EPSON PhotoPC 3000Z Revision A
Disassembly and Assembly Assembly 64
4.3 Assembly
4.3.1 Assembling the Lens Assembly
1. Check if there is no dust or scratch on the surface of the Optical Filter (2)
and install it toe the LENS ASSY (1).
NOTE: Be careful at the direction when installing the Filter. (See
Figure 4-7.)
2. Insert the SPACER (3).
3. Remove the protective sheet of CCD (4) and check if there is no dust or
scratches on the surface and install the CCD, aligning with guide rib of the
holder.
4. Install the MOUNTING LENS (5), aligning with guide pin of the holder and
secure it with 3 screws (6) (1.7x6).
5. Install the SPACER INSULATOR (7), aligning the guide pin of the holder.
6. Attach the PAD (10) to the Lens.
Figure 4-6. Installing the PAD
7. Install the CA1 (8) holder, aligning with the guide pin and the CCD
terminal and secure it to the MOUNTING LENS with 2 screws (9) (1.7x2.5).
8. Solder the CCD terminal to the CA1.
Figure 4-7. Assembling the Lens Assembly
Attaching position
Attaching position
CCD side Lens side
Thin side