Epson PhotoPC 3000Z, Service Manual

Page: 62 / 109

EPSON PhotoPC 3000Z Revision A
Disassembly and Assembly Disassembly 62
4.2.3 Removal of SY1 and LCD
The following is the discharging process of SY1 and LCD. Disassembling
procedure should follow numbers indicated in the figure below.
Figure 4-3. Removal of SY1 and LCD
4.2.4 Removal of CA1/2 Board and Lens Assembly
The following is the discharging process of CA1 Board, CA2 Board and Lens
assembly. Disassembling procedure should follow numbers indicated in the
figure below.
Figure 4-4. Removal of CA1, CA2 and Lens Assembly
A D J U S T M E N T
R E Q U I R E D
When replacing the LCD, perform the LCD panel adjustment.
(See Ch5.)
1. Screw 1.7 x 4
2. Two screws
1.7 x 5
3. Connector
5. SY1 board
4. Connector
6. Screw
1.7 x 4
7. Three screws
1.7 x 5
8. Connector
9. FPC
10. LCD
11. Holder monitor
A D J U S T M E N T
R E Q U I R E D
When replacing the CA1 board, CA2 board, or lens assembly,
perform the adjustment. (See Ch5.)
C A U T I O N
Be careful at its direction when installing the optical filter of
the lens assembly. (See “Assembly” on page 64.)
A