Epson Photo PC-750Z, Service Manual, Page: 47 / 94

EPSON PhotoPC-750Z Revision A
Disassembly and Assembly Overview 47
10. Solder the shield case from the back of the CA1 board. (Total 6
soldering positions)
11. Solder the one side of the black cable (about 5.5 cm) for prevention
of radiation (electric noise) to the soldering point, which is located
below the Viewfinder.
12. Insert FPC cable coming out of the lens unit to CN9511 and fix it.
Figure 4-9. Parts Installation to the CA1 Board (2)
C A U T I O N
The destination of the cable soldered on the shield
case is the soldering point around the (-) side of the
power capacity (for backing-up) on the SY1 board.
C
N
9511
S h i e l d C a s e
S o l d e r i n g P o s i t i o n s
2 ) A c a b l e f o r p r e v e n t i o n o f
r a d i a t i o n ( 5 . 5 c m )