Epson MovieMate 25, User Manual

Page: 55 / 76

55
Solving problems using external video equipment
The remote control does not
work Is the Function/Numerics toggle switch in the [1 2 3] (numerical input)
position? page 19
Depending on the disc, certain operations are prohibited. -
Are the batteries dead, or have the batteries been inserted correctly? page 8
No sound can be heard or
the sound is faint. Has the volume been adjusted to the minimum setting? page 13
Is mute mode active? Press .
-
Is the DVD level setting set to [DVD LEVEL 1]? page 41
The audio distorts Is the volume too loud? page 13
The audio/subtitle language
cannot be changed If multiple languages are not recorded on the disc, they cannot be
changed. -
Subtitles do not appear If there are no subtitles on the disc, they are not displayed. -
Is the subtitle language set to “Off”? page 32
When you use A-B repeat, subtitles may not be displayed before and
after point A and point B. -
When this happens . . . Check the following:
Reference
page
No images appear Is the power for the connected equipment turned on?
Switch on the power to the connected equipment then start playback. page 37
When signals have been connected to both the S-Video input port and
the Video input port, only the S-Video signal is available. If you want to
watch the video equipment connected to the Video input port,
disconnect the cable from the S-Video input port. -
“Signal not supported” is
displayed If you cannot project even when the “Video Signal” is set to “Auto” in
the video Information menu, set to the signal format appropriate to the
equipment. page 51
“No signal” is displayed Are the cables connected correctly? page 36, 37
Is the power to the connected equipment turned on?
Switch on the power to the connected equipment then start playback. page 37
Press to switch to the connected equipment.
page 37
The signal is distorted If an extension cable is used, electrical interference may affect the
signals. Connect amplification equipment and check. -
Image is cut off (too large)
or too small MovieMate automatically recognizes and projects the aspect ratio for
the input signal. If the aspect ratio is not projected correctly, press
and select the aspect ratio appropriate to the input signal.
-
Image colors are not right In the video Information menu, set the “Video Signal” to the signal
format appropriate to the equipment. page 51