125
While the firmware is updating, all of the status indicators on the projector start flashing and the cooling
fans run at high speed (this is normal). After the update is complete, the projector enters standby mode.
If the
Direct Power On
setting is enabled, the projector restarts automatically.
After the update is complete, check the
Version
setting in the
Management
>
Information
menu to
confirm that the firmware was updated successfully.
Parent topic:
Updating Projector Firmware Using a Computer and USB Cable
You can update the projector firmware using a computer and a USB cable.
Note:
You need a USB Type A to USB Mini-B cable.
Your computer must be running one of the following operating systems when updating firmware:
• Windows 8.1 (32- and 64-bit)
• Windows 10 (32- and 64-bit)
• macOS 10.13.x (64-bit)
• macOS 10.14.x (64-bit)
• macOS 10.15.x (64-bit)
1.
Download the projector firmware file from the Epson support website. Make sure it is the correct
firmware file for your model.
2.
Turn on the projector.
3.
Connect the USB cable to the computer's USB port and to the projector's
Service
port.
4.
Press the
Menu
button, select
Initial/All Settings
>
Firmware Update
and press
Enter
.
5.
Select
Yes
to start the firmware update.
Note:
Do not disconnect the power cable or remove the USB cable while the firmware is updating.
All of the status indicators on the projector start flashing, and the projector enters firmware update
mode. The projector appears as a removable drive on the connected computer.
6.
Copy the downloaded firmware file onto the root (top) directory of the projector's removable drive.
Note:
Do not rename the firmware file.
Summary of Contents for LS11000
