Making Wi-Fi Settings by Push Button Setup
You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏
The access point is compatible with WPS (Wi-Fi Protected Setup).
❏
The current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the access point.
1.
Hold down the [WPS] button on the access point until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
2.
Press the
button on the printer until the
light and the
light flash alternately (approximately 3
seconds).
The connection setting will start. When a connection is established, the
light turns on.
Note:
The printer is in a connection error status when the
light and the
light flash simultaneously. After clearing
the printer error by pressing the
button on the printer, reboot the access point, place it close to the printer and try
again. If it still does not work, print a network connection report and check the solution.
Related Information
&
“Checking the Network Connection Status” on page 22
&
“Printing a Network Connection Report” on page 22
User's Guide
Network Settings
19
