Rev. A
Operation Principles 2-23
EU-T532/T542 Technical Manual
Confidential
(*1): Do not set SW 3 to ON in the following condition:
•
The partial cutter is used when the cut sheet presenter module is not used.
When backward paper feeding is enabled, the following process is executed.
•
After cutting the paper with a
GS V
command, backward paper feeding is executed. (When the Black
mark sensor is disabled.)
•
The print starting position adjustment with a
GS (F
command can be set to the backward direction
relative to the cutting position. In this case, the maximum backward correction value is 14 mm {0.55"}
(112 step
×
0.125 mm {0.005"} per step).
(*2): Specific offline means the following states.
•
Error state except an automatic recovery error state
•
Platen open
•
Cut sheet presenter module or cover open
•
Paper empty
If this switch is turned on, the printer clears the receive buffer when the offline status shown above occurs. Then
the printer executes any real-time command (
DLE ENQ
,
DLE EOT
) if it is there, and discards all other data.
When the receive buffer is cleared, if this switch is turned on, three bytes of data, 37H, 24H, and 00H, are
transmitted.
Table 2-12 Memory Switch 8
SW No.
Function
ON (1)
OFF (0)
Default setting
1 to 2
Print control mode
Refer to 2-13
OFF(0)
3
Backward paper
feeding
Enabled
Disabled
OFF(0) (*1)
4
Autocutter
installation
Not installed
Installed
OFF(0)
5
Specific offline
operation
Discards receive
data
Keeps receive data
OFF(0) (*2)
6
Backward paper
feeding amount
88 steps
108 steps
OFF(0)
7
Test print when the
paper is loaded
Enabled
Disabled
8
Black mark position
Initializes the BM
position
Not initialize the BM
position
Table 2-13 Print Control Mode Selection
Default for the print
control mode
SW 1
SW 2
Non-divided energizing
mode
OFF
OFF
Two-part energizing
mode
ON
OFF
Four-part energizing
mode
Either ON or OFF
ON
