Epson EMP-TW100, User Manual

Page: 59 / 68

57
Appendices
Rear
Base
Trigger port
When the projector power is turned
on, 12 V DC is output from this port.
When the projector's power is turned
off, the output becomes 0 V to
communicate the projector's power
ON/OFF status to an external device.
Remote control light-
receiving area
(
Setup Guide )
Receives signals from
the remote control.
Main power switch
(p.6)
Press to turn the main
projector’s power on and
off. When the power is off,
the power consumption is
0 W.
Rear adjustable foot
Extend and retract to
adjust the horizontal
projection angle.
Power inlet (p.6)
Connects the power
cord.
InputA port (
Setup Guide
)
Inputs component video signals
from other video sources.
S-Video port ( Setup Guide )
Inputs an S-Video signal to the
projector from other video sources.
A-RGB/D-RGB DVI-I port
(
Setup Guide
)
Inputs digital/analog RGB video
signals from a computer.
InputB port (
Setup Guide
)
Inputs analog RGB video signals from a
computer and component video signals from
other video sources.
RS-232C port
Connects the projector to a computer using an
RS-232C cable.
This port is for service use, and should not
normally be used.
Video port
(
Setup Guide )
Inputs composite video
signals to the projector
from other video sources.
Air filter (air inlet) (p.44, 48)
Prevents dust and other foreign particles from being drawn into the projector.
When replacing the lamp, replace the air filter also.
Rear adjustable foot
Suspension bracket fixing points (4 points) (p.49, Setup Guide )
Install the optional ceiling mount here when suspending the projector from the
ceiling.
Front adjustable foot
Front/Top Rear Remote control
Control panel Base