Epson EB-L30000U, User Manual

Page: 238 / 283

i
If the password screen is displayed, enter the password you set in
step 3 for
Remote Camera Access - Password , and then press
OK .
A message is displayed on the projected image, and shooting starts.
It takes approximately six seconds to acquire the image.
a

Adjust the exposure as necessary. If you make any
adjustments, shoot again and check the adjusted image.

When shooting, you cannot perform any operations except for
turning off the projector.

You cannot shoot warning or caution messages.
Using the Mail Notification Function to Report
Problems
When you set Mail Notification, notification messages are sent to the preset
email addresses when a problem or warning occurs with a projector. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
s
Network - Notifications - Mail Notification p.159
a

Up to a maximum of three notification destinations (addresses) can
be registered, and notification messages can be sent to all three
destinations at once.

If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.

If you set Standby Mode to Communication On , you can control
the projector even if it is in standby mode (when the power is
off).
s
Extended - Standby Mode p.147
Reading error notification mail
When the Mail Notification function is set to On and a problem or warning
occurs in the projector, the following email will be sent.
Sender: The email address set in From
Subject: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The main message
contents are listed below.

Clean Air Filter (Air Filter Notice)

Constant brightness expired (Constant Bright. End)

Internal error (Internal Error)

Fan related error (Fan Error)

Sensor error (Sensor Error)

Laser error (Laser Error)

Laser warning (Laser Warning)

Retardation Plate Error (Retardation Plate Error)

Internal temperature error (High Temp Error/Overheating)

High-speed cooling in progress (High Temp Warning)

Low Air Flow (Low Air Flow)

Low Air Flow Error (Filter Airflow Error)
Monitoring and Controlling
238