Troubleshooting
86
f
EMP NS Connection cannot be used to make a connection
Check the message at the bottom-left of the screen and then apply the following countermeasures.
f
Suddenly changes to the EasyMP screen
ERR at the bottom left of the screen: Check the numbers and make the following remedies.
f
When a connection is made using EMP NS Connection, the projected image remains as is, and a connection cannot be made from another
computer.
Error Messages
Remedy
The application version used is not supported.
You are using an old version of EMP NS Connection. A connection cannot be made. Install the current
version from the EPSON Projector Software for Meeting & Presentation CD-ROM supplied with the
projector.
ERR Number
Error Meaning
Remedy
2,50,53,245,-103
Failed to startup EasyMP.
Turn the power for the projector off and then back on again.
51,52,100
Failed to process EasyMP.
When using EMP NS Connection, reconnect EMP NS Connection.
When using USB display, reconnect the USB cable.
-101
Communication was cut off from the access point.
Check the access point operation.
-102,-105
Wireless communication is unstable.
Check the situation of network traffic, and reconnect EMP NS
Connection after waiting for a while.
Check
Remedy
Did the presenter leave the conference room without
cutting off the network connection?
With EMP NS Connection, the connection with the computer that was previously connected can be cut off
when another computer tries to connect with the projector, and it connects with the computer that is trying to
connect.
Therefore, when a projector keyword is not set for the projector, or if you know the projector keyword, you
can cut off the current connection and, if you perform a connection operation, you can connect to the
projector.
When a projector keyword is set for the projector, if you do not know the projector keyword, cut off
projection from the projector and reconnect. To cut off connection from the projector, press the [Esc] button
on the remote control, select "Close" from the close menu and press the [Enter] button on the remote control.
When it cuts off, you can connect from the target computer.