Epson DFX-9000 Field Repair Guide
3/29/07
Adjustments
Printer Component,
Software Item,
LCD Display,
Printer Button
Page 192.
APTC Detection Position Adjustment
Note: Before performing this adjustment, the TOF Sensor Sensitivity Adjustment and the Parallelism
Adjustment must be performed.
This adjustment is required if you:
•
Replace the
Printer Mechanism
•
Remove or replace the
Carrier Unit
•
Replace the
ROM Board
(only when the EEPROM Data Copy failed)
1.
Turn the printer on.
2.
If the front paper path is not selected (indicated by a red
LED
on the
Control Panel’s Paper Path Indicator
, see
the figure below), depress the
Front/Rear
button on the Control Panel one (1) time. Verify that the red
LED
on
the
Control Panel’s Paper Path Indicator
is lit.
3.
Mount one (1) sheet of 18# or 20# pinfeed paper onto the
front set of tractors
.
4.
Load the paper by depressing the
LF/FF Load
button on the
Control Panel
one (1) time.
5.
Run the DFX-9000 Adjustment Program.
6.
Select “DFX-9000” as the “Model Name”.
7.
Select “EAI” as the “Destination”.
