Epson ColorPage EPL-C8000, Service Manual

Page: 190 / 545

EPSON EPL-C8000 Revision B
Chapter 3 Disassembly and Assembly/Adjustment 3-48
3.2.8.10 REGI. RUBBER ROLL Removal (PL5.2.24)
1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MAIN P/H ASSEMBLY. (See Section 3.2.8.1.)
4. Remove the REGI. CLUTCH. (See Section 3.2.8.7.)
5. Remove the REGI. BRAKE CLUTCH ASSEMBLY. (Refer to Section
3.2.8.8.)
6. Remove the REGI. METAL ROLL. (Refer to Section 3.2.8.9.)
NOTE: In the following steps, be careful not to drop and lose the
REGI. FRONT SPRING and REGI. REAR SPRING.
7. Remove the front E-ring fixing the REGI. RUBBER ROLL to remove
the REGI. GEAR.
8. Taking out the front REGI. LOWER BEARING, remove the REGI.
FRONT SPRING and REGI. LOWER BEARING.
9. Remove the E-ring securing the REGI. RUBBER ROLL by the rear
end. Then, taking out the rear REGI. LOWER BEARING, remove
the REGI. LOWER BEARING and the REGI. REAR SPRING.
NOTE: In the following step, be careful not to damage the mylar film
attached onto the P/H FRAME ASSEMBLY.
10. Lifting up the rear end of the REGI. RUBBER ROLL, pull out the roll
to the upper rear to remove.
Figure 3-54. REGI. RUBBER ROLL Removal
C H E C K
P O I N T
When installing the REGI, RUBBER ROLL, be careful
not to damage the mylar film attached onto the P/H
FRAME ASSEMBLY.