Epson ColorPage EPL-C8000, Service Manual

Page: 19 / 545

EPSON EPL-C8000 Rev. B
Chapter 1 PRODUCT DESCRIPTIONS 1-3
1.2 Specifications
This section describes specifications for this printer.
1.2.1 Basic Specifications
o
Method: Semi-conductive laser beam scanning and dry
electrophotographic process
o
Resolution: 600 DPI
o
Print mode:
n
B/W mode: Standard monochrome print mode that supports
the fastest speed.
n
Color mode: Color mode which uses the color toner of Y, M, C,
and BK.
o
Speed mode:
n
Standard mode: Transports paper at the highest speed
supported by the printer.
n
Half speed mode: Low speed mode that enables better fusing
for thick paper (over 105g/m
2
) envelopes,
and OHP sheet.
o
Print Speed: See Table 1-1.
Notes:
*1. In this mode, the printer prints tow print images on the IBT belt and
the images are transferred in sequence onto two sheets of paper. It
is available for LT/A4 (LEF) or smaller.
*2. [LEF, or Long Edge Feed]
The longer edge of the paper is the top toward the paper feed direction.
[SEF, or Short Edge Feed]
The shorter edge of the paper is the top toward the paper feed direction.
o
First print*:
- Face-up B/W:
20 seconds or less (LT/A4 LEF)
Color: 42.6 seconds or less (LT/A4 LEF)
- Face-down B/W: 24.9 seconds or less (LT/A4 LEF)
Color: 47.6 seconds or less (LT/A4 LEF)
NOTE:Fist print is defined as the duration taken after receiving the
start command until outputting the first print. It is applicable
when a feeder is selected in the standard mode. (Not applied
during the process control operation.)
o
Warm-up time: Within 300 seconds
(at 22 degree Celsius, 58% Rh, rated voltage)
Table 1-1. Speed Mode
Print mode Speed mode LT/A4 LEF 2UP (*1) B(LD)/A3 SEF (*2)
B/W Standard mode 16 PPM or more 8PPM or more
Half speed mode 2.7 PPM or more 1.3PPM or more
Color Standard mode 4 PPM or more 2PPM or more
half speed mode 1.8 PPM or more 0.9PPM or more