Epson 7900p - PowerLite XGA LCD Projector, User Manual

Page: 49 / 146

Projecting
49
Adjusting Color Corrections for a New Surface
Adjust the correction values if you’re projecting on a new surface or in
a new location.
1. Press the
Wall Shot
button on the remote control or projector
while you’re projecting an image. Wait for the Wall Shot status
screen.
2. Press the
Wall Shot
button until you see
Wall Shot
Readjustment
on the status screen.
You see a sequence of colors flash for about five seconds as the
projector adjusts the color correction values for the new
projection surface.
Shutting Down the Projector
When you’ve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. Turn off and disconnect any equipment plugged into the
projector.
2. To turn off the projector, press the red
P
Power
button on the
projector or remote control.
You see a confirmation message. (If you don’t want to turn it off,
press any other button.)
note
When the projector has not
received any input signals
for 30 minutes, it
automatically turns off the
projector lamp and enters
“sleep mode.” This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the
P
Power
button.
If you are done using the
projector, unplug the power
cord. To turn off sleep mode,
see page 76.
Turn off this product when
not in use to prolong the life
of the projector.
Power button
Power OFF? Power OFF?
Yes Yes : : Press button Press button
No No : : Press any other button Press any other button