Epsolar LS0512R, Instruction Manual, Page: 12 / 40

8
NOTE: When mounting the controller, ensure free
air through the controller heat sink fins. There
should be at least 6 inches (150 mm) of clearance
above and below the controller to allow for cooling.
If mounted in an enclosure, ventilation is highly
recommended.
WARNING: Risk of explosion! Never install the
controller in a sealed enclose with flooded batteries!
Do not install in a confined area where battery
gassed can accumulate.
Step 1: Choose Mounting Location
Locate the controller on a vertical surface protected from direct sun,
high temperature, and water. And make sure good ventilation.
Step 2: Check for clearance
Place the controller in the location where it will be mounted. Verify
that there is sufficient room to run wires and that there is sufficient
room above and below the controller for air flow.