44
8 Hydro Generation Function
SPIRIT 1.0 Evo outboard can drive the propeller to charge the battery (only the
ePropulsion battery) through water flow.
The machine will enter the hydro generation state if the following conditions are
met:
1.
The Evo control system is set to turn on the hydro generation function (enabled by
default).
2.
The Evo control system is in the zero position.
3.
The ePropulsion battery power is below 90%.
4.
The machine will enter the hydro generation state after the boat speed is above
6km/h stable for 4 seconds.
5.
If using E-series battery or NAVY battery, please connect with a communication
cable.
When any of the following conditions occur, the hydro generation will be stopped:
1.
The Evo control system is set to turn off the hydro generation function.
2.
The Evo control system is in the forward / backward state (not in the zero
position).
3.
The ship is not traveling or traveling too fast (higher than 35km/h).
4.
The battery level is higher than 90%.
The hydro generation function can be used only when connecting ePropulsion
batteries.
Set up the hydro generation function
When the
Evo control system
and the machine are successfully connected, and the
Evo control system
and the outboard are both on. Press the “ ”, “
^
” and “
” but
-
tons at the same time to enter the hydro generation setting interface. Then press “
” to change the state of the hydro generation function (En means off, Dis means on).
Figure 8-1
