EPOX EP-GXB-M, Manual

Page: 28 / 90

EP-GXB-M Hardware Installation
Page 28
Installing Processor(s)
The EP-GXB-M supports two Intel Pentium II Xeon processors. This section
outlines the procedure to install one or two processors into the mainboard. The
chassis (case) must supply additional screw holes and support standoffs so the
retention mechanism may properly support the Xeon. There is also a possible need
for rubber bumpers between the mainboard and case surface to prevent shock and
vibration.
1. Observe the safety precautions as listed on page 24 for handling static sensitive
devices.
2. Place the two plastic bases of the retention mechanism on both ends of the Slot 2
connectors and secure in place using screws supplied (see figure 4). The bases
contain small plastic pegs that will insert in to small holes to prevent incorrect
usage.
3. Included with the mainboard kit are two caps that attach to the Xeon processors as
shown in figure 5 (one shown). Attached this cap to the top of the processor (see
figure 6). This will act as a handle allowing the user to insert the processor into the
complete retension mechanism.
Dual retension mechanism
bases.
Figure 4