
BIOS
EP-BX3
Page 4-13
4-4 Power Management Setup
Choose the “POWER MANAGEMENT SETUP” in the CMOS SETUP UTILITY to
display the following screen. This menu allows the user to modify the power
management parameters and IRQ signals. In general, these parameters should not
be changed unless it’s absolutely necessary.
Figure 5: Power Management Setup
ACPI Function: This option allows you to select ACPI Function.
The default is Enabled.
Enabled: Support ACPI function for new O.S
Disabled: No Support ACPI function.
You can only change the content of Doze Mode, Standby Mode, and Suspend
Mode when the Power Management is set to ‘User Define’.
Power Management: Use this to select your Power Management selection.
The default is User define.
Disabled:
The system operates in NORMAL conditions (Non-GREEN), and
the Power Management function is disabled.
Max. saving: Maximum power savings. Inactivity period is 1 minute in each mode.
Min. saving: Minimum power savings. Inactivity period is 1 hour in each mode.
User define: Allows user to define PM Timers parameters to control power
saving mode.
ROM PCI/ISA BIOS (2A69KPAB)
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
ACPI Function
: Enabled
Power Management
: User Define
** Reload Global Timer Events **
PM Control by APM
: Yes
IRQ [3-7, 9-15], NMI
: Disabled
Video off Method
: V/H SYNC+Blank
Primary IDE 0
: Disabled
Video off After
: Standby
Primary IDE 1
: Disabled
Modem Use IRQ
: 3
Secondary IDE 0
: Disabled
Doze Mode
: Disabled
Secondary IDE 1
: Disabled
Standby Mode
: Disabled
Floppy Disk
: Disabled
Suspend Mode
: Disabled
Serial Port
: Enabled
HDD Power Down
: Disabled
Parallel Port
: Disabled
Throttle Duty Cycle
: 62.5%
PCI/VGA Act-Monitor
: Disabled
Soft-off by PWR-BTTN
: Delay 4 Sec.
CPUFAN Off In Suspend
: Enabled
Power Loss Recovery
: Disabled
Resume by Alarm
: Disabled
IRQ 8 Break Suspend
: Disabled
Esc : Quit
: Select Item
F1 : Help
PU/PD/+/- : Modify
F5 : Old Values
(Shift) F2
: Color
F7 : Load Setup Defaults
é
é
é
é
é ê
ê
ê
ê
ê è
è
è
è
è ç
ç
ç
ç
ç
Summary of Contents for EP-BX3
