page | 10
FINE TUNE
After making all connections and calibrating the speakers, fine tune the subwoofer as instructed below. See
pages 4
‒
5 for more on menu functions.
NOTE:
When using an AV receiver and the LFE input, set the subwoofer calibration level to the factory setting,
and select LFE for CROSSOVER.
1.
Ensure that the subwoofer is plugged in.
During initial setup, set the POWER CONTROL to FRONT PANEL. Once calibration is complete, switch to AUDIO
SENSE to enable the automatic power-saving mode. For reference, the different modes are as follows:
FRONT PANEL:
Always on. Amplifier does not turn off automatically. Turn the unit ON/OFF using the front
panel power button.
12V TRIGGER:
Amplifier turns on when 12V signal is detected and off when 12V signal is absent.
AUDIO SENSE:
Audio Sense enabled. Amplifier turns on when audio signal is detected. Unit enters standby
mode if no signal is detected after 15 minutes.
2.
Select the desired EQ setting or set to FLAT (unmodified sound). Set the controls to positions that will enable
tuning for maximum performance.
FLAT: Unmodified Sound
Setting
Value
Initial Volume
50
Initial Crossover
Set to 170Hz, or set to LFE if LFE input is used
Initial Phase
0
°
NOTE:
If deeper bass is desired, adjust the CROSSOVER control toward the lower frequencies. Experiment
with different frequency settings until finding one that sounds best.
When using the LFE input, set to LFE and
make any crossover adjustments in the preamplifier or receiver crossover settings.
DUAL8: Optimized for use with Dual 8
"
In-Wall Subwoofer
Setting
Use Case
Value
Initial Volume
(1) ES-SUB-IW-DUAL8
53
(2) ES-SUB-IW-DUAL8
50
Crossover
LFE*
Initial Phase
0
°
NOTE:
*AVR bass management, usually @ 80Hz for most in-wall/in-ceiling speakers with open back volume.
BSUB12: Optimized for use with Burial Subwoofer
Setting
Use Case
Value
Initial Volume
(1) ES-LS-BSUB-12-CPR and
(2) ES-LS-SAT-6-BRN (8Ω)
50
Crossover
ES-LS-SAT-4-BRN
120 Hz
ES-LS-SAT-6-BRN
110Hz
ES-LS-SAT-8-BRN
100Hz
Initial Phase
0
°
HSUB10: Optimized for use with Hardscape Subwoofer
Setting
Use Case
Value
Initial Volume
(1) ES-LS-HSUB-10-BLK and
(2) ES-LS-SAT-6-BRN (8Ω)
53
Crossover
ES-LS-SAT-4-BRN
120 Hz
ES-LS-SAT-6-BRN
110Hz
ES-LS-SAT-8-BRN
100Hz
Initial Phase
0
°
3.
Play a movie scene or music track and set the system volume to an average level. Listen to the bass level
from the preferred listening position. Adjust the VOLUME control as desired.
4.
Continue listening to music and movie sources using the settings chosen for volume and crossover.
5.
Experiment with the PHASE until finding the best setting. Depending on the subwoofer placement, the bass
may sound louder or deeper when the phase has been optimized. In some cases, adjusting phase will make
no discernible difference.
