2. Installation and Getting Started
Advanced configurations
Install Guide
Page 21
Contact your network administrator if you are not sure what
information to use. The IP address, Network Mask, Default
Gateway, and DNS Server that you assign must be compatible
with the network.
8
Select
Apply
to save these changes.
9
Select
Continue
.
10
Select
Maintenance
and then select
Reboot Now
.
It takes a few minutes for the device to reboot.
11
After a few minutes log into the Web admin interface by
browsing to its new IP address. For example, browse to:
http://192.168.1.20/admin/
12
Enter the Web admin interface user name and password to
login.
13
Once you have confirmed that you can log into this VGA
Bridge device disconnect it from the network.
14
For each additional VGA Bridge device, power on and connect
the device to the network and repeat this procedure. Make
sure you give each VGA Bridge device a different IP address.
Advanced configurations
Multiple receivers on the same network can all receive images
from a single transmitter. No configuration changes are required
as long as there is only on transmitter on the network. The
receivers automatically find the transmitter and receive images
from it.
If you have multiple transmitters on the same network you must
configure each receiver to select a transmitter to receive images
from. To do this you must make configuration changes using the
receiver’s Web admin interface. If you do not make these
configuration changes you may have unexpected results.
See the
for more information.
