ZING 24 ALIGNMENT
2. Adjustments of this mirror are made
using the three (3) 3/32” allen head screws,
each of which move the laser/red dot
in a different direction on the target.
The movement each screw controls are
shown below:
3. On the Zing keypad, press the X/Y OFF
button and move the carriage to position
3, shown at the beggining of this proce-
dure,
4. Use the adjustment screws on mir-
ror #3 to move the red dot diode to the
center of the alignment target. Since the
red dot diode and CO2 laser paths are
now joined, adjusting mirror #3 will adjust
them both.
4. Once the red dot diode is aligned over
the center of the alignment target, ap-
ply a dab of super glue or another sim-
ilar adhesive to each adjustment screw
head, letting it also drip down to the
adjustment screw plate, thereby helping
to “lock in” the alignment.
5. Press the POINTER button on the Zing
keypad to turn off the red dot diode.
6. Replace the left side panel of the Zing
engraver.
Conclusion
This concludes the CO2 laser alignment
for the Zing 24 engraver. If further assis-
tance is needed, please reach out to
Epilog Technical Support.
