ZING 24 ALIGNMENT
Before Starting
Direction
Many of the instructions provided in this
procedure will have a direction given,
such as left-hand side or right-hand side.
Unless otherwise stated, these are all pro-
vided as though you were facing the ma-
chine from the front.
Table Positions
For the following procedures, the table will
be broken into the three (3) positions seen
below. Each position is identified by its rel-
ative distance to the laser source.
Mirrors and Red Dot Pointer
The three (3) mirrors and the red dot
pointer that are used to align the laser
are located under the left side panel of
the machine. Throughout this procedure,
the mirrors will be referenced by number,
as seen below.
Mirror Locations:
1
2
3
Red Dot Diode Location:
Compared to Other Models
The Zing 24 alignment procedure is
unique to this specific model as the op-
tics within the laser tube are much dif-
ferent than other Epilog Laser engraver
models. Attempting to utilize other align-
ment instructions not intended for the
Zing 24, including those designed for the
Zing 16, will result in unsuccessful align-
ment and “loss” of the red dot diode and
laser fire.
If at any point during the alignment pro-
cedure you lose sight of the red dot di-
ode or unable to get a burn mark on the
alignment target, contact Epilog Tech
Support.
Epilog Tech Support Contact Information:
www.epiloglaser.com
303-215-9171
1
2
3
