7
3
3. Insert the Rear Frame (2) into the Front Frame
(1);
make sure that the Ramp (3) is on the
Lift Roller (12).
Attach the Rear Frame (2) with five M8 x 19mm
Screws (82) and five M8 Split Washers (83).
83
83
83
2
3
12
1
82
82
82
4. Have a second person orient the Upright (4) as
shown and hold it near the Front Frame (1).
Locate the wire tie in the Upright (4). Tie the
lower end of the wire tie to the Wire Harness
(110). Next, pull the upper end of the wire tie
until the Wire Harness is routed completely
through the Upright. Then, untie and discard the
wire tie.
Tip: To prevent the Wire Harness (110) from
falling into the Upright (4), secure the Wire
Harness with a rubber band or tape.
Tip: Avoid pinching the Wire Harness (110).
Slide the Upright (4) onto the Front Frame (1).
Attach the Upright (4) with four M8 x 19mm
Screws (82) and four M8 Split Washers (83);
do
not tighten the Screws yet.
4
Wire
Tie
Wire
Tie
Avoid pinching the
Wire Harness (110)
4
1
82
82
82
83
83
110
All manuals and user guides at all-guides.com
