7
8. Identify the Left Pulse Sensor Bar (26) and the Right
Pulse Sensor Bar (124); the Pulse Sensor Bars are
marked with stickers. While another person holds the
Pulse Sensor Bars near the Upright (4), connect the
upper pulse wires to the lower pulse wires. Insert the
excess wire into the Upright.
Orient the Pulse Sensor Bars (26, 124) as shown.
Attach the Pulse Sensor Bars to the Upright (4) with
four M8 x 16mm Button Screws (94), being careful
not to pinch the wires.
4
Upper
Pulse Wire
94
10
20
10
9. Identify the Front Center Pivot Cover (27). Attach the
Front Center Pivot Cover to the Frame (1) with four M4
x 16mm Screws (89).
Next, identify the Rear Center Pivot Cover (28). Attach
the Rear Center Pivot Cover to the Frame (1) with four
M4 x 16mm Screws (89).
9
8
28
27
89
94
94
Lower
Pulse Wire
Lower
Pulse Wire
Upper
Pulse
Wire
10.Apply a small amount of the included high-temperature
lubricant to a paper towel, and rub a thin film of the
lubricant onto both of the Pivot Shafts (10). Next, apply
a small amount of grease to the axle in the Upright (4).
Then, slide a 5mm Spacer (35) onto each end of the
axle in the Upright (4).
Next, slide the two Pivot Arms (20) onto the Pivot
Shafts (10), and turn the Pivot Arms so the flanges are
facing away from the elliptical exerciser. Then, slide
the Pivot Arms onto the ends of the axle in the Upright
(4); use a rubber mallet, if necessary.
Slide an M8 x 23mm Washer (103) onto an M8 x
25mm Patch Screw (123). Attach the left Pivot Arm
(20) to the left end of the axle with the Patch Screw.
Attach the right Pivot Arm (20) to the right end of the
axle in the same way.
89
89
89
20
Flange
10
Grease
Lubricate
4
35
123
103
Grease
26
124
4
