21
12
!-Pull the retaining washer out of th
body through the jet hole
Using the same hook/wire, pull the o-
ring seal through the hole in the body
from which you removed the valve
operating pin in step-7.wash body, cove
and jet area as needed, using kerosene
or equivalent petroleum solvent. Do
NOT use carburetor, as it will attack
synthetic rubber seals.
13
Seal holder(H1-14236, bottom tool)
should be placed as shown. place the
greased o-ring seal into the holder,
using
the installation pin(P1-14235 upper
tool).recoat the seal with silicone
grease. The seal must be in the position
shown in the photo, groove facing
up, and visible, Seal is tapered to match
hole in the seal holder.
14
