Copyright EnvironmentalLights.com
All Rights Reserved 10/1/18
4
Wiring for Over 30A:
•
Make sure that the power supply is turned off before wiring the device.
•
Use at least 14AWG stranded wire for power supply connections and at least 12AWG for
runs greater than 10ft or 3m.
•
Connect the negative side of the power supply to both “DCV-” terminals. Use two runs of
wire into each terminal for connections over 10ft or 3m.
•
Connect the positive side of the power supply and the positive LED leads to both
“DCV+” and both “LED+” terminals.
•
Connect the negative side LED wires to the terminals marked “R”, “G”, “B” and “X” for
red, green, blue and white. Refer to the DMX Address section below for more
information.
Figure II: Wiring Diagram for Over 30A