INSTALLATION & ASSEMBLY:
1.
Remove fixture from box.
2.
Open the
door frame
(#1) by rotating the two
cam latches
(#2) [Fig. 1].
3.
Remove the
lamps
(#3) from the packaging
material and put them in a safe place [Fig. 1].
4.
Remove the
wire cover
(#4) by squeezing and
releasing it from
locking tabs
(#5) [Fig. 1].
5.
Close the
door frame
(#1) and place the fixture
on a 2 ft by 4 ft T-bar grid in the desired location
[Fig. 2].
6.
From above the ceiling, secure troffer to T-Bar
by bending built in
T-bar clips
(#6) on all four
corners of fixture [Fig. 3].
7.
If local code requires, tie a wire to at least two of
the four
T-bar clips
(#6) to a structural member
of the ceiling.
8.
Remove the
access plate
(#7) and locate
fixture supply wires
(1 black & 1 white) [Fig. 3
& 4].
9.
Remove one
knockout
(#8) in
access plate
(#7)
and pull
fixture supply wires
through
knockout
(#8) opening [Fig. 4 & 5].
10. Make electrical connections according to local
code.
11. From below ceiling, open the
door frame
(#1)
and replace the
wire cover
(#4) by squeezing it
into the
locking tabs
(#5) [Fig. 1].
12. Install
lamp
(#3) with side labeled
“power” on the
lamp holders closest to the
access plate
(#7).
13. Close the
door frame
(#1) using the two
cam
latches
(#2) [Fig. 1].
14. Turn power on.
Page 4
3
Fig. 1
Fig. 4
Fig. 3
Fig. 2
