8
Operating Instructions
For Your Safety, Read Safety Precautions And
Lighting Instructions Before Operating
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR EXPLOSION MAY
RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OF LOSS OF LIFE�
P
iLot
L
ighting
i
nstRuctions
:
Figure 2: Lighting Instruction Label
1. STOP! Read the safety information above on this label.
2. Set the thermostat to the lowest setting.
3. This appliance is equipped with an on-demand pilot that shuts off after
7 consecutive days of main burner inactivity.
4. Turn off all electric power to this appliance.
5. Open the front control panel for valve knob access.
6. Turn off the gas control knob clockwise
to the “OFF” position.
7. Open door. Wait fIve (5) minutes to clear out any gas.
Close door. Then smell for gas, including near the floor. If you smell gas,
STOP! Follow “B” in the safety information above on
this label. If you don’t smell gas, go to the next step.
8. Find pilot - located close to the burner(s). Turn the gas control
knob counter-clockwise to “PILOT”. Push the gas control in fully and
hold, keep knob depressed for about 60 seconds after the pilot is lit or until
an audible
“BEEP”
is heard. Release knob. If pilot goes out,
repeat steps 4 through 5.
WARNING
: This gas valve has a
lockout device, which will not allow the pilot burner to be relit
until the thermocouple has cooled.
-If the knob does not pop up when released, stop and immediately
call your service technician or gas supplier.
-If the pilot will not stay lit after several tries, turn the gas control
knob clockwise to “OFF” and call your service
technician or gas supplier.
9. Turn the gas control knob counter clockwise to the “ON”
position. Flip the burner switch to “ON” then turn the “HI/LOW”
knob to the desired setting.
10. Close the front control panel.
11. Turn on all electric power to the appliance.
12. Set thermostat to desired setting.
4. Turn the gas control knob clockwise to the “OFF” position.
5. Close the front control panel.
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life
A. This appliance has a pilot which must be lighted by hand. When
lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance. Do not touch any electrical switch; do
not use any phone in your building. Immediately call your gas supplier
from a neighbor's phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don’t try to repair it. Call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to the lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Open the front control panel and flip burner switch to “OFF”
C-16294
Gas Control Knob
Pilot
Summary of Contents for Westport Steel
Page 45: ...45 Notes...
Page 46: ...46 Notes...
