Initial Installation
QUALIFIED INSTALLERS ONLY
R
eaR
v
ent
c
onveRsion
:
If desired, the S30I can be converted from a top vent to a rear vent unit by following the steps below.
Note:
When converted to rear vent the S30I has a smaller range of allowable venting, refer to
I
nItIal
I
nstallatIon
- a
llowaBle
V
entIng
c
onfIguratIons
before final installation.
Step 2:
Next, remove the vent
collar, base plate, cover plate and
exhaust spigot (28 screws total)
as shown in Figure 24.
Vent Collar
Base Plate
Exhaust Spigot
Cover Plate
Figure 23. Vent Conversion - Step 1
Figure 24. Vent Conversion - Step 2
Cast Top
Back Plate
Step 1:
Using a T20 screwdriver
loosen the four screws retaining
the back plate and unhook it. Then
remove the cast top by simply lifting
up as shown in Figure 23.
Cast Top - Rear
Mounts
20
