Page 16
Maintenance And Service
b
uRneR
R
emovaL
:
The burner may need to be removed for a few reasons, including cleaning under the burner or to be
replaced all together.
Proceed only when the unit has completely cooled down.
Figure 10. Removing Burner
Step 1:
Remove the glass door as shown in
the
m
aIntenance
anD
s
erVIce
- g
lass
D
oor
r
emoVal
.
Step 2:
Remove the log set and fire grate
as shown in S
econDary
I
nstallatIon
- f
Ire
g
rate
anD
l
og
s
et
I
nstallaIon
Step 3:
Pull the burner up and then out of the
venturi box and out.
To re-install the burner follow steps 1-3
in reverse. When placing the burner back
in the unit be sure not to move the air
shutter. Insure the front and rear lengths
of the burner tube are parallel as it may
have distorted with heat over time.
The
ideal placement for the burner tube
is keeping it forward up against the
burner stand stops.
DATE: 8/6/2014
BY
SHERWOOD INDUSTRIES LTD.
INTERNAL ASSEMBLY MANUAL
THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED WITHOUT THE PRIOR APPROVAL OF SHERWOOD INDUSTRIES LTD.
1 of 1
SHEET:
STOVE:
UPDATED: ----/--/--
BY --
REVISION:
0.0
Figure 11. Removing Access Door
a
ccess
D
ooR
:
Step 1
: Remove the burner as shown in
the
m
aIntenance
anD
s
erVIce
- B
urner
r
emoVal
.
Step 2:
Remove the Upper Air Diverter
by removing (2) T-20 bolts. Remove
the Lower Air Diverter.
Step 3
: Remove the right and left burner
stands by removing (4) T-20 bolts.
Step 4
: Remove the (16) T-20 bolts
retaining the access door as shown in
Figure 11.
Step 5
: After serviving assemble in the
reverse order and be sure the gasket is
still intact. Replace if necessary.
There is an access door in the bottom on the firebox that is used for servicing components after the unit
is installed in a construction enclosure.
Proceed only when the unit has completely cooled down.
