43
Secondary Installation
Figure 55. Complete log set-up with embers.
Figure 56. Q1LI complete log set-up with coal nuggets burning.
Maintenance:
Once a year, the logs should be removed and checked for deterioration or large amounts
of soot. A small amount on the bottom side of the logs is normal. Remove and replace the logs in the
same manner described above.
If new coal nuggets or logs are required, contact your nearest ENVIRO dealer.
Never operate the fi replace with the glass door removed.
Step 5
: Finally, install the large
straight twig between the center
and left side log grate upright by
locating the notch on the bottom
side with the log grate cross bar.
The top of the twig will rest on top
of the far right curved twig. The
last remaining straight twig gets
intalled by locating the front in the
crook of the far left y shaped twig
and the back notch rests on the
top edge of the ember bed.
Figure 56: The Q1LI burning
with a good fl ame.
NOTE: While the glass is still
removed, it is recommended
that the gas line be purged by
lighting the pilot.
When lighting the fi replace
for the fi rst time since the log
set and embers have been
installed/replaced, watch for
ignition at ALL the burner ports.
If a long delay is noticed, turn
the appliance off and wait for it
to cool down. Then remove the
glass and make sure none of the
burner ports are blocked.
