![Enviro EG 40 B Owner'S Manual Download Page 8](http://html1.mh-extra.com/html/enviro/eg-40-b/eg-40-b_owners-manual_2415747008.webp)
INSTALLATION OF LOG SET and EMBERS
INSTALLING THE GLOWING EMBERS
A bag of ceramic fiber embers is provided for use on the front burner ember tray.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the
ember material there may be more than required. Use only a single layer. Do not pile embers. The use of other
foreign materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement, contact the nearest ENVIRO
dealer for replacement embers.
Gently remove the ember material from the plastic bag. Spreading pieces evenly across the front and rear of the
ember tray.
Do not pack down the embers. Leave embers loose.
DO NOT PLACE EMBERS ON THE REAR BURNER.
CAUTION: NEVER OPERATE THIS
APPLIANCE WITH THE DOOR REMOVED
INSTALLING THE LOG SET
Carefully remove logs from box. Check to ensure
there is no damage. It is very important to install
these logs in their proper position to insure safe,
optimum operating conditions. Open the front door
place logs on guide pins as per picture. Close the
door and tighten securely.
Upon the first light up, watch for ignition to
all
burner
ports. If a long delay is noted: First, wait for the
appliance to cool down. Open the front door of the
appliance. Check to carefully reposition the embers
making sure that burner ports are not plugged solid or
blocked. (See adjusting the venturi section to adjust air
for proper flame).
IMPORTANT NOTE:
When the unit
is turned on for the first time, it should be turned onto
high without the fan on for the first 4 hours. This will
cure the paint, logs, gasket material and the other
products used in the manufacturing process. It is
advisable to open a window or door, as the unit will
start to smoke and can irritate some people. After the
unit has gone through the first burn, turn the unit off
including the pilot, let the unit get cold then open the
glass door and clean it with a good gas fireplace glass
cleaner, available at your local ENVIRO dealer. (See page 10. cleaning glass)
8