MAINTENANCE AND TECHNICAL
Periodically check to ensure that your "Direct Vent"
system is clear.
Periodically check the pilot and burner. Check to see
that all the burner ports are clean and clear. Check
the pilot head for blockage. Check to ensure the pilot
flame is blue with small yellow tips.
OPENING THE DOOR
Caution
door is hot when in operation.
1. Open the right hand hinged side flap, which will
expose a door fastener. Using a 1/2" wrench, loosen
the fastener.
2. Due to the shape of the bay window door. You
must also open the left-hand side flap before
attempting to open the door.
CLEANING OF GLASS
Do not clean glass when hot
It will be necessary to clean the ceramic glass
periodically. During a cold start up, condensation will
sometimes form on the glass, this is a normal
condition with all gas fireplaces and stoves. However,
this condensation can allow dust and lint to cling to the
glass surface. Initial paint curing of the appliance can
leave behind a slight film on the glass. This is a
temporary problem. It is therefore recommended that
the glass be cleaned initially after about the first two
weeks of use.
After that, depending upon the amount of use,
cleaning should be required no more than two or three
times per season.
To clean the door, use a mild glass cleaner and a soft
cloth. Abrasive cleaners will damage the glass and
gold surfaces. Close door tightly.
TO REPLACE DOOR AND GLASS ASSEMBLY
The glass in this appliance is an integral part of the
door assembly. If the glass is damaged or broken a
replacement door assembly including glass must be
fitted.
To Replace:
•
open door fully
•
Lift door vertically so that hinge pins lift out of
hinge receivers.
•
Return the door assembly to dealer.
Door and glass assembly must be replaced as a
complete unit by your ENVIROGAS Dealer.
No substitute materials are allowed.
FOR CLEANING THE INSIDE OF THE FIREBOX
Remove the log carefully from the firebox. Gently
remove the embers and place on a piece of paper
towel, until ready to replace.
Vacuum the firebox thoroughly. Carefully clean off
any dust on the logs and remove any lint from the
main burner and pilot burner.
After carefully replacing the log and embers in their
correct positions, and the door has been resealed, re-
light the pilot, following the instructions on the attached
label.
CLEARANCES MUST BE SUFFICIENT TO ALLOW
ACCESS FOR MAINTENANCE AND SERVICE
16
