27
Secondary Installation
s
uRRounD
P
aneL
i
nstaLLation
:
WARNING:
The surround becomes hot when the unit is operating; ensure that the unit is turned off,
and that it has cooled to room temperature before beginning this installation.
Height
Width
3-Sided Surround
25” (635 mm)
39
7
/
8
” (1013 mm)
4-Sided Surround
31
1
/
2
” (800 mm) 39
7
/
8
” (1013 mm)
Table 7: Surround Dimensions.
Please check components supplied with this kit. If components are missing or have been damaged,
contact your dealer, distributor or courier company before starting this installation.
IMPORTANT:
The panel must not seal ventilation openings in the fireplace.
INSTALLATION (3 and 4 sided Surrounds):
Lift the face upright in front of the fireplace with the six hooks pointing towards the fireplace. Slide
the hooks over their corresponding screws (see Figures 36 & 37). Ensure the hooks are secure before
releasing the surround. The surround should be wiped with a damp cloth periodically. Screws can be
tightened for a more permanent install.
REMOVAL:
Lift the surround straight up in order to unhook the notch on the hooks from the screws. Pull the surround
away from the fireplace. Place the surround where it will not be damaged.
Figure 36: Screw Locations.
Figure 37: Screw and Hook Close-Up.
BURNER SWITCH WIRING INSTALLATION:
The burner switch supplied with the surround comes pre-installed and wired. The wiring from the burner
switch simply needs to be connected to the wiring on the E30G unit.
The wiring harness for the burner switch has one (1) blue wire, one (1) grey wire and two (2) purple
wires.
The blue wire connects to the blue wire on the E30G unit, the grey wire connects to the grey wire on the
E30G unit, and the purple wires are used to connect an optional thermostat.
CLEANING:
Painted surfaces should be periodically wiped with a damp cloth.
Never clean the face when it is hot.
Access Panel
removed for
clarity.
