31
L
OG
S
ET
AND
E
MBER
I
NSTALLATION
:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched”
and will not burn correctly. The burner (Figure 42) and a few of the logs come with locator pins, notches,
and ledges which make alignment easier. The andirons and grate must be installed for the logs to be
placed properly. Using the pictures provided, carefully set the logs in place (see Figures 43 through 49).
NOTE: The logs are fragile and should be handled gently.
Maintenance:
Once a year the logs should be removed and checked for deterioration or large amounts
Figure 42. Placement of ledges and pegs in empty
firebox.
Secondary Installation
C
ERAMIC
B
RICK
L
INER
R
EMOVAL
:
WARNING: DO NOT INSTALL LINER IF UNIT IS HOT.
1. Remove glass door (see
M
AINTENANCE
A
ND
S
ERVICE
- G
LASS
D
OOR
R
EMOVAL
)
2. Carefully remove the log set if it was installed.
3. Remove both side brick liners by sliding them out the front. Be careful not to scrape the liners on the
baffle tabs at the top.
4. Hold the back of the top liner up while lifting the back liner off the air deflector ledge then out. Slide
the top liner out from the lip on the baffle then remove it from the unit.
of soot. A small amount on the bottom side of the
logs is normal. Remove and replace the logs in the
same manner described in this section.
If new/more embers and rock wool is required,
contact your nearest ENVIRO dealer.
Never operate the fireplace with the glass
door removed.
Figure 42: This is how the fire box looks with only
the andirons and grate in place. This points out the
three ledges at the back and three locator pins on
the burner.
Right Side Brick Liner
Leftt Side
Brick Liner
Top Brick Liner
Back Brick Liner
Air Deflector Ledge
Baffle Lip
Baffle Tab
For clarity unit is not shown.
5. If the baffle needs to be removed use a T-20
screwdriver to loosen off but not remove the
two (2) screws at the back of the baffle and
remove the two (2) screws at the front of the
baffle. Slide the baffle up over the back screws
then out.
To install the liners follow steps 1 to 5 in reverse.
Important installation notes:
Ensuring the side brick liners are behind the baffle
tabs and are flush against the firebox walls.
When sliding the baffle into place making sure
to hook the back into place on the two loosened
screws.
To install the log set follow the instruction in
L
OG
S
ET
AND
E
MBER
I
NSTALLATION
.
Figure 41: Cast Iron Brick Liner Installation.
