Figure 49: Once the logs are in place the embers can be placed onto and around the burner to create
a realistic look. Bags of ceramic fiber embers and rock wool are provided. The ceramic fiber comes in
chunks that are about 2” (51 mm) long. Place them irregularly around the burner. When there is a
sparse but even layer of embers, spread the rock wool in the same manner. DO NOT pack this ember
material as this could create an
unsafe condition. The pieces
should be lightly placed so they
don’t completely block any of
the small burner ports. DO NOT
allow any of the embers to rest
against the pilot assembly.
Caution:
Use only the type of
ember material supplied with this
fireplace. Due to the irregular
size of the ember material, there
may be more than required. Use
of other foreign materials on the
burners may create dangerous
conditions.
Figure 49. Complete log set-up with embers.
Figure 50. DV50DX complete log set-up with embers burning.
Figure 50: The DV50DX
burning with a good flame.
NOTE: While the glass is still
removed, it is recommended
that the gas line be purged
by lighting the pilot.
When lighting the fireplace
for the first time since the
log set and embers have
been installed / replaced,
watch for ignition at ALL
the burner ports. If a long
delay is noticed, turn the
appliance off and wait for it
to cool down. Then remove
the glass and rearrange the
ember material, making
sure none of the burner
ports are blocked.
Secondary Installation
34
