13.
Re-attach the hinged side flaps by sandwiching the
surround panels between the mounting brackets and the
hinged side flaps. secure with screws.
14. Re-install the stove top by inserting the locating screws,
previously put into the surround panel top, through the
holes in the back of the stove top. Push threaded studs
through holes in top baffle and tighten nuts. Re-attach the
top grill bar.
15.
Be sure to maintain adequate clearances around air
openings,
do not block
.
16.
Place the log and ember set into the fire box. See
instructions in section 11, INSTALLING LOG AND EMBER SET.
OPTIONAL ADJUSTABLE SKIRT FOR RAISED FIREBOX APPLICATIONS
ASSEMBLING YOUR ENVIROGAS 828 FREESTANDING APPLIANCE
1. Open the two hinged side panels, open the door.
2. Remove log and ember set and all wrapping material from the
stove. Check for damage. If damage is observed, do not use
unit and contact your local dealer.
3. Remove the two wood screws that secure the stove to the
pallet, these are located through the square openings inside
the side panels.
4. Place the stove on its back on the pallet. Pre-thread the 4
holes in the base of the stove that secure the pedestal to the
stove using the 4 screws ( 5/16 hex washer heads) provided.
Place pedestal so that the holes in the base of the stove align
with those in the pedestal and tighten screws by hand first.
Then tighten with a 5/16 socket wrench.
5. Return the unit to the upright position reinstalls the log set
and embers as per instructions in section 11.
7
Summary of Contents for 828 BV. INS.
Page 20: ...20 ...
