Quick Start Manual
50479 (STORM24)
for more information visit:
enttec.com/storm24
The DMX port
represents one of the physical ports on
the rear of this unit, select which port you want to use by
using the drop down.
•
Rate: refresh rate to send DMX (frames per
second)
•
Break: Break time (micro sec) between each DMX
frame (default is 200)
•
MAB: Mark After Break time (micro sec) default is
52
•
Channels: Number of channels to send in 1
Universe (default is 512)
Limitation
: Same DMX port cannot be re-used in the same
profile
Art-Net Stream:
"Send IP address": is the destination
address used when the stream is sending data only.
ESP Stream
: ENTTEC Show protocol DMX over
Ethernet stream (ESP). IP address is the destination
address used when the stream is sending data only.
Kinet Stream
: For example: You can connect Kinet
Stream to an Art-Net Stream to convert and output as
Art-Net. (Kinet stream is supported as input only)
Streaming ACN
: "IP address" is the destination address
used when the stream is sending data only
(default is disabled = 0.0.0.0)
DMX Generator
: Define your own custom DMX Channel
values and assign the selected ones.
Snapshot feature can be used to capture values from an
input stream. All modifications can be done using the
DMX Grid Page.
Clock:
Allows you to synchronize ALL DMX output only
when the connected Input Stream is received.
•
Auto-repeat allows user to repeat the output once
every "number of seconds" reagrdless of Synced
Stream
•
Default behaviour [Auto-repeat = Never]: Will only
refresh DMX when Synced Stream is received
The Clock module can be used to make sure the output is
always synced to the “latest universe” - especially if the
source adds a delay to each univere. This will keep all
outputs in sync with the latest one.
5
