Pixel Triton User Manual
Part No.: 51322
For latest version visit:
www.enttec.com
25 October 2018
mfile ID: 4815381
Page|
9
Fader Test
Pixel Triton has in-built web faders for instant
testing of setup at each output. When enabled, this
feature switches on all LEDs controlled by the
mapped pixels specified. The faders override any
ArtNET/sACN input data.
The number of faders displayed per output
depends on the pixel order selected. For the image
shown above, output 1 has 4 faders as the pixel
order selected is RGBW. However, output 2 has 3
faders as the pixel order assigned is RGB.
The faders will stop sending data if the disable
fader radio button is selected
Reboot Device
Reboot button, which is under settings pages
restarts the unit
Reset to Defaults
The reset to defaults command can be found under
the Settings tab
Once the command is pressed, a pop-up would
appear as shown in the image below:
Once confirmed, a loading screen will appear as
shown in the image below:
Once finished, the page will automatically refresh,
and the following parameters will be updated to
reflect the reset to defaults:
•
DHCP enabled
•
Static IP Address reset (IP address = 10.(byte
1).(byte 2).(byte 3) where the three bytes are
the last three bytes of the mac address in
decimal)
•
Netmask reset to 255.0.0.0
•
Gateway to 10.0.0.254
•
DMX protocol to ArtNet
•
LED protocol to WS2812B family of protocols
•
Universe/output reset back to 4
•
Pixel order set to RGB
