User Manual
Pixel Port
For the latest version visit:
www.enttec.com
21 September 2017
ID: 3617472
P a g e
|
15
•
Enables DHCP
•
IP
Address
reset
(IP
address
=
10.(octet1).(octet2).(octet3) where the three
octets are the last three octets of the mac
address in decimal)
•
The 2nd LED from top remains red
•
When Home option is clicked on, device
starts behaving as DHCP is enabled
Before reset
•
Restores first 15 presets to factory default.
Using Button
The reset button restores the configuration of the
Pixel Port to factory defaults:
•
DHCP is enabled
•
Static IP Address reset (IP address =
10.(octet1).(octet2).(octet3) where the three
octets are the last three octets of the mac
address in decimal)
•
Netmask is set to 255.0.0.0
To reset to factory defaults, the following procedure
must be performed:
•
Power off the unit
•
Press and hold the Reset button.
•
While holding the Reset button, power up
the unit, and keep holding the button for 3
seconds.
•
Release the Reset button once the status led
starts blinking red.
•
Wait 3 seconds and cycle power
Tips and Tricks
Pixel Tape/Dots are to be connected to the output
using the connector provided
Choosing a Pixel Port
When choosing a Pixel Port consider the following:
•
What is the voltage of the LED tape/Dots used?
•
What is the power requirement of the display?
The maximum power limit and the output voltage for
the Pixel Port is provided in the table below:
Product
Part No.
Output
Voltage
Maximum
Power
Maximum
Current
76302-16
12V
65W
5.41 A
73602-26
24V
65W
2.7 A
73602-55
5V
55W
10 A
Unable to open Pixel Port web-page:
You must ensure that the Pixel Port and your
computer are on the same
subnet
To troubleshoot:
1.
Give your computer a Static IP address (e.g.:
10.0.0.1)
2.
Change computer Netmask to (
255.0.0.0
)
3.
Please connect the Pixel Port directly using a
cat5 cable to your computer
4.
Now use NMU to select the correct network
(10.0.0.1)
5.
If you have multiple networks (wifi etc.),
please try to disable all other networks except
the one Pixel Port is connected to.
6.
Once NMU finds the Pixel Port, you will be
able to open the device web-page and