URC Quick Reference Guide
5
V2.0
8. Autoscan Programming
If your home entertainment device does not respond to the remote control
after trying all codes listed for you brand, or if your brand is not listed at all,
try searching for your code. For example, after trying all of the code for your
device you still cannot get the remote control to operate your device, then:
1.
Power on the device and on the remote control, press the desired
device key once. Then press and hold SETUP until the device key
blinks twice, then release SETUP.
2.
Press the POWER key once and aim your new remote at the device.
3.
Press either the “CHANNEL UP” key or “CHANNEL DOWN” key to do
device auto-scan.
4.
Note: In this search mode, the remote control will send IR codes from
the library in 5 second intervals. The device key will be on and blink
every 5 seconds while in the device scan mode.
5.
If the device turns off, a working code has been found. Press OK once
to lock in the code. The selected mode key will blink twice.
6.
If all code sets of that device are exhausted in the search and the OK
is not pressed, the selected device key will fast blink 7 times and the
search mode will be terminated.
© Entone, Inc., San Mateo, California 2006-2007
